Windows 2003 Installation C-3
6. Type ch? to display information about using channels. The following screen
is displayed:
Channel management commands:
ch List all commands.
Status legend: (AB)
A: Channel operational status
‘A’ = Channel is active.
‘I‘ = Channel is inactive.
B: Channel Type
‘V’ = VT-UTF8 emulation.
‘R’ = Raw – no emulation.
ch – si <#> Switch to a channel by its number.
ch – sn <name> Switch to a channel by its name.
ch – ci <#> Close a channel by its number.
ch – cn <name> Close a channel by its name.
Press <esc><tab> to select a channel.
Press <esc><tab>0 to return to the SAC channel.
7. Press Esc Tab to find an empty channel. You can now use text-based
commands (MS-DOS) for Windows 2003.
8. If operating system redundancy is required, make a mirrored drive of
Microsoft Windows 2003 on the NEC Express5800/1000 series server (see
the next section).
Creating a Mirrored Drive of Windows 2003
Use the following procedure to create a mirrored drive of Microsoft
Windows 2003 on the Express5800/1000 series server.
Note: Perform the following procedure after
Windows 2003 is installed and operating on Disk 0.
1. Make Disk 1 GPT. If Disk 1 has been formatted only, use Disk Management
to convert Disk 1 to GPT.
To Next Page
Loading...
