System Operation 2-3
4. Locate the server LAN cable at the rear of the server cabinet. Connect a
client PC to the server LAN connection.
Note: A LAN cable either comes already connected to
the Service Processor board or it is connected by the NEC
technician during the server installation.
5. Connect peripheral devices, such as a monitor, mouse, and keyboard, to the
rear of the server. Video and I/O board connectors are at the rear of the
PCIX Unit. See Figure 2-2 for typical connector locations.
A Rear of PCIX Unit
B Slot with VGA Monitor Board
C Slot with I/O Board Mouse and
Keyboard Connectors
Figure 2-2. Video Board and I/O Board Connector Locations
!
CAUTION
When connecting a cable to an I/O board, be sure to leave
enough cable free for sliding the PCIX unit out of the
cabinet. Route the cable so it does not get pinched or
damaged.
Route the external device cables under the rear door frame
and out of the way of the rear server door.
6. Close and lock the rear server door.
CBA
To Next Page
Loading...
