2-6 System Operation
9. Enter up on the SP console to bring up the specified partitions
(see Figure 2-5).
The service processor turns on power to the specified partitions, initializes
the hardware, and hands off the control to the BIOS. The BIOS boots the
operating system.
iSPyz:---> up<ENTER>
This command will bring up the specified partition.
Enter partition number (0-7/all/CR=exit) : all<ENTER>
Execute OK? (y/[n]) y
<ENTER>
UP command was accepted. All partitions will run soon.
[iSPyz:INFO.ccc] partition 0 : power on sequence started.
[iSPyz:INFO.ccc] partition 1 : power on sequence started.
:
[iSPyz:INFO.ccc] partition 1 : power on sequence completed normally.
:
[iSPys:INFO.ccc] partition 1 : handed off the control to BIOS.
Figure 2-5. System Startup Screen
To Next Page
Loading...
