Service Processor 3-7
Table 3-5. Main Menu Login Events and Operations
Event Operation
The account or password is invalid. Displays “incorrect” and then displays the login
prompt again.
The account or password is invalid three times
in a row.
Disconnects the session.
Left for 5 minutes in login or password prompt
state.
Displays “timeout” and then disconnects the
session.
A character not on the menu is entered. Displays the menu again.
Left for 5 minutes in menu display state. Displays “timeout” and then disconnects the
session.
A switch of the iSP master occurs while the
menu is displayed, making the menu invalid.
Changes are not immediately reflected in the menu
display and prompt.
When you select an invalid menu, the selection is
ignored and a new menu is displayed.
0 – 7 selected.
(Only those of the master iSP are valid)
Switches to the OS (BIOS) serial console
redirection.
S selected.
(Valid regardless of master/backup)
Switches to the SP Command Console.
V selected.
(Valid only in the master iSP)
Switches to the Virtual SOP.
E selected. Disconnects the session.
DISCONNECTALL selected. Disconnects all connections with iSP except the
connection under operation.
This operation occurs only in special situations
(such as the case where a connection with the
service processor was actually disconnected but
remains under service processor management due
to irregular access of a client to the service
processor; as a result, any further operation cannot
be performed).
After a DISCONNECTALL is selected,
authentication with Maintenance Mode is performed.
The number of simultaneous connections
allowed for the selected menu is exceeded.
Displays “N connections to the selected mode are
already established. Try it later.” Displays the Main
Menu again.
To Next Page
Loading...
