4-44
SPANNING OF RAID5
1. Open the configuration creation screen.
Select "Configure" → "New Configuration" from the TOP menu to display the screen shown below. This is
the Channel-1 menu screen where the cursor is put on ID=0 position:
2. Select ID-0/1/2 hard disks.
Pressing
Space changes the display for Channel-1, ID=0 to "ONLIN A01-01" where "A01-01" is blinking.
(The cursor automatically moves to Channel-1, ID=1.) In the same way, press
Space on Channel-1, ID=1.
(Where "A01-02" is blinking, the cursor moves to Channel-1, ID=2.) In the same way, press
Space on
Channel-1, ID=2. (Where "A01-03" is blinking, the cursor moves to Channel-1, ID=3.) After selecting 3 hard
disks (Channel-1, ID=0/Channel-1, ID=1/Channel-1, ID=2), press
Enter to determine the settings. (Display
on each hard disk stops blinking.)
To Next Page
Loading...
