4-74
Writing Update Data into BMC
When you click [
], update data will be written into BMC.
For each update target, the window showing update progress appears.
If any error is detected during update, an error message appears and the update is terminated.
Completion of Writing
When writing is completed, results appear in the [Status] column per [Target].
OK
OK
NOTES:
For targets other than applet, reboot the server or power off and then on the server to
apply the update.
If you reboot the server or power on the server to apply the BMC firmware update,
connection to BMC is disconnected. To continue using, log in again.
To apply applet update, log out and shut down all browsers, and then log in again. You
do not need to reboot the server.
To Next Page
Loading...
