EasyManua.ls Logo

NEC Express5800 140He - Page 231

NEC Express5800 140He
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8-21
Error
code
Error message Recommended Action
8171
Processor 2 not operating at intended
frequency
8172
Processor 3 not operating at intended
frequency
8173
Processor 4 not operating at intended
frequency
817F
All processors not operating at intended
frequency
Check the frequency of the processor. If it is unknown, contact
your service representative.
8200 Online Spare Memory was not ready.
DIMM type mismatch is detected when the online spare memory
feature is enabled.
Contact your service representative.
8201 Mirroring Memory was not ready.
DIMM type mismatch is detected or unnecessary installation in
group #2 is detected when the memory mirroring feature is
enabled. Check the DIMM type or installation. If the error cannot
be corrected, contact your service representative.
8202 Memory RAID was not ready.
Check if capacity, type, and installation status of all DIMMs are
correct.
8300 Secondary BIOS is corrupted. Contact your service representative.
Other POST Errors
The following message does not appear on the screen, however, it is recorded in the system event log.
Error
code
Description Recommended Action
8301
A BIOS Checksum error was detected in
the early stage of BIOS boot-up
(Bootblock). The control was transferred
to the secondary BIOS. (See Chapter 2
"Recovering BIOS Data".)
Contact your service representative.

Table of Contents

Related product manuals