TERMINAL SETUP
18
TERMINAL SETUP
■ While you set up terminal, the “soft
key” means local soft key.
■ If the Back / Exit button is pressed
while the terminal setting menu is
displayed, Favorite screen is displayed
regardless of the home screen
settings.
ADJUSTING VOLUMES
Display Example while adjusting volumes level
TO ADJUST HANDSET RECEIVER
VOLUME
It is possible to adjust the volume level of the
handset receiver during a call in progress using
handset.
Press Up /Down key in the offhook status or during
a call when using the handset.
TO ADJUST SPEAKER VOLUME
It is possible to adjust the volume level of the
speaker during a call in progress using speaker.
Press Up /Down key during speakerphone
operation or during a call using the speaker.
TO ADJUST RINGER TONE
It is possible to adjust the volume level of the ringer
tone during incoming call arrival.
Press Up /Down key during ringing.
TO SET RINGING OF HEADSET
Following explains how to enable/disable the ringing
of headset.
This feature is required both in the
terminal and in the system settings at
initial installation. For details, please
contact the system administrator.
1.
Display the Menu screen, and select “Settings”
2.
Select “
1
User Settings”.
3.
Select “
1
Incoming Call”
4.
Select “
3
Headset Ring”.
5.
Select whether to ring the headset ringer.
TO SET RINGER TONE
This section explains how to set a ringer tone
WHEN DISTINCTIVE RINGING
PATTERNS TO DISTINGUISH INTERNAL
AND EXTERNAL INCOMING CALLS ARE
PROVIDED
Leave the setting of “Ring Tone” to “ Automatic”
(default setting).
Use each default ringer tone for both
external and internal incoming calls.
Ringing pattern is programmable on a
system basis. For details, please
contact the system administrator.
To Next Page
Loading...
