OPERATION
43
SYSTEM
Call screen is displayed when you make a call,
receiving an incoming call, or using system service.
You can use system soft key instead of dialing
feature number. Available key is displayed
according to the terminal status.
Display patterns or name of system
soft key are set at initial installation.
For details, please contact the system
administrator.
HOW TO SELECT A SYSTEM SOFT KEY
DT930 (24CG)
Use the cursor keys to move orange focus to a
desired system soft key and press the enter key.
However, depends on the initial settings, a screen
such as following is displayed. In this case, the
system soft key can be selected by pressing each
soft key assigned.
In addition, cursor keys can be used as follows.
Since the local soft keys in the Call screen
disappear in this mode, the local soft keys cannot
be used. Therefore, you need to press the right
cursor key if you need the Directory, or go to the
Favorites screen if you need the History screen. For
more details, please contact your administrator.
DT930 (Touch Panel model)
Tap the system soft key. Only when the item is
selected, the orange focus is displayed for about 1
second.
DT920 (Self-Labeling model)
Press programmable key on the sides of screen.
To display next system soft key page,
select “>>>”.
If there is no next page, “>>>” is not
indicated.
Up and down cursor key are used for
adjustment volume on this screen. It is
not available for selecting system soft
key.
SAMPLE DISPLAY
Soft keys provide a set of functions on the LCD that
according to the changing state of the terminal.
IDLE
To Next Page
Loading...
