CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 95 – NWA-008847-001 Rev.3.0
a6ch1001.fm
4: Connected party terminal/Card type
• For station: STNX-XXXXXXXX (X-XXXXXXXX=STA. No. [1-8 digits])
• For IP-PAD: PADXXX (XXX=IP-PAD Channel No. 000-255)
• For IP-CS: IPCSXXX-Y (XXX=CS No. 000-255, Y=B Channel No. 0-2)
• For connected party: M_XXXXXXXX (XXXXXXXX=Logical Collection Position No.
[8 digits])
NOTE: SIP is output as “connected party”.
5: IP address of connected party: XXX.XXX.XXX.XXX
6: Number of sent RTP packets: XXXXXXXX (8-digit fixed hexadecimal value)
7: Number of received RTP packets: XXXXXXXX (8-digit fixed hexadecimal value)
8: Number of received RTP packets lost: XXXXXXXX (8-digit fixed hexadecimal value)
• Conditions for call log collection of SIP trunk are as follows.
• This feature is available with the Series 3700 R12.2 software version or later.
• Call log of SIP trunk is notified from SIP trunk to MP card when sending/receiving of RTP
packet are completed.
• For the number of RTP packets sent in call log, the number of transmissions of SIP trunk is
saved.
• For the number of RTP packets received in call log, the number of receptions of renewable
packets is saved.
JULY/01/2006
VoIP LOG COLLECTION
To Next Page
Loading...
