CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 104 – NWA-008847-001 Rev.3.0
a6ch1001.fm
STATION SERVICE STATUS DISPLAY
[Series 3700 R12.2 software required]
General Description
This feature enables to readout the setting status of the service feature for each station.
Service Conditions
(1) The service features whose setting status can be readout by this feature are the features that are set
to single line telephone, D
term
, D
term
IP, PS, virtual station and built-in modem. The features that are
set to Attendant Console and ISDN terminal are not supported.
(2) Station numbers entered by the setting status readout command (CME4 Y=00, 01) are the station
number set to single line telephone, D
term
, D
term
IP, virtual station, virtual station for PS, and built-in
modem. The station numbers for ISDN terminal and PS station cannot be entered ([DATA ERROR]
is displayed if entered).
(3) The terminal connection status and the line status cannot be readout in offline. For the other features,
the status can be readout regardless of online or offline.
(4) For the line status, when Sub Line is accommodated to D
term
/D
term
IP and My Line number is input
to the first data, the status “Line is busy (1)” is displayed when incoming/outgoing calls to My Line,
and the status “Line is idle (0)” is displayed when incoming/outgoing calls to Sub Line.
(5) For Day/Night mode change, Day mode (D)/Night mode (N)/Mode A (A)/Mode B (B) are displayed
even if two kinds modes (Day mode/Night mode) is set by CM65 Y=29.
JULY/01/2006
STATION SERVICE STATUS DISPLAY
To Next Page
Loading...
