NEC NEAX 2000 IPS - Service Conditions

CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 88 – NWA-008847-001 Rev.3.0
a6ch1001.fm
Service Conditions
(1) General conditions
• Terminals/cards and available firmware versions that enable to collect fault logs/call logs are as
follows.
NOTE: Fault information store/display is not available for the following D
term
85 (Series i) (IP Bundled
Type). But it will be available when the new firmware is installed.
- ITR-8D-2 (BK/WH) TEL (Available when firmware of ITR-8D-3 (BK/WH) TEL is installed)
- ITR-16D-2 (BK/WH) TEL (Available when firmware of ITR-16D-3 (BK/WH) TEL is installed)
- ITR-8D-2A (BK/WH) TEL (Available when firmware of ITR-8D-3A (BK/WH) TEL is installed)
- ITR-16D-2A (BK/WH) TEL (Available when firmware of ITR-16D-3A (BK/WH) TEL is in-
stalled)
- ITR-8D-2U (BK/WH) TEL (Available when firmware of ITR-8D-3 (BK/WH) TEL is installed)
- ITR-16D-2U (BK/WH) TEL (Available when firmware of ITR-16D-3 (BK/WH) TEL is in-
stalled)
• Collected fault logs and call logs can be output to a PC via the RS port (RS-232C) of the MP card.
To output the fault logs and call logs, communication software (Hyper Terminal, etc.) must be in-
stalled in the PC (MATWorX cannot be used while using the communication software).
Terminals/Cards
Available: ×
Not available: -
Firmware Version
Fault Log
Collection
Call Log
Collection
Terminals D
term
85 (Series i) (IP Adapter Type) ××Ver. 2.80 or later
D
term
85 (Series i) (IP Bundled Type)
NOTE
××Ver. 2.80 or later
D
term
IP INASET (ITR-240G-1) ××E0 2.80 or later
D
term
SP30 ××F Ver. 7.3.0.0 or later
IP-CS ××SC-3375 8A or later
D
term
75 (Series E) (IP Adapter Type) - -
D
term
IP INASET (ITR-LC-1) - -
D
term
SP20 - -
Cards PN-8IPLA (IP-PAD) ××SC-3386 IPS IPADT
PROG-C1 or later
PN-32IPLA/PN-32IPLA-A (IP-PAD) - -
PN-8IPTA (SIP) - × SC-3591 IPS IPATT
PROG-B1 or later
PN-IPTB (IPT) - -
JULY/01/2006
VoIP LOG COLLECTION