CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 12 – NWA-008847-001 Rev.3.0
a6ch1001.fm
Programming Procedure
(1) To set the fault information storage from the CAT/MAT by Command Operation
DESCRIPTION DATA
Enable the fault information storage fea-
ture.
(1)
(2)
450
1 : To store
Specify the processing at the time of fault
storage memory overflow.
(1)
(2)
451
0 : No fault information is registered in
case of Fault Memory overflow
1 : Fault information is overwritten in
case of Fault Memory overflow
Assign which kind of fault information is
stored into the fault information memory,
and which kind of alarm is indicated.
•
(1)
(2)
Y=2
See the following table.
See the following table.
NOTE: CMEA programming can be set by the Fault Storage in MAT.
CMEA
CM08
START
A
JULY/01/2006
FAULT MESSAGE
To Next Page
Loading...
