NEC NEAX 2000 IPS - Programming Procedure

CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 56 – NWA-008847-001 Rev.3.0
a6ch1001.fm
Programming Procedure
Example
For CCIS programming, refer to the CCIS System Manual.
For IP programming, refer to the IP System Manual or NEAX 2000 IPS System Manual.
For Center Office
DESCRIPTION DATA
Assign the Originating Point Code (OPC)
for the center office.
NOTE 1: CCH/IPT No.0 must be assigned
for Centralized MAT in center of-
fice.
NOTE 2: The Originating Point Code is
used to designate an originating
office in CCIS/IPT network. A
single OPC should be assigned to
all CCH/IPT numbers provided
in the same office.
•Y=01
(1) 0-7 : CCH/IPT No.0-7 NOTE 1
(2) 00001-16367: OPC NOTE 2
Centralized MAT:
Each office in the
network is recognized
by the Point Code.
Point Code: 10010
PBX No. : 0002
Point Code: 10000
PBX No. : 0001
Point Code: 10011
PBX No. : 0003
Local Office Center Office
(CME3 Y=02
is assigned)
Local Office
PBX
number
Local Office:
The fault information and PBX
number are sent to the center office.
PBX
number
Point Code
Center Office:
PBX number is converted to Point
Code according to the data assigned
by CME3 Y=02.
PBX No.
0001
0002
0003
POINT CODE
10000
10010
10011
START
CMA7
A
CENTRALIZED MAT