NEC NEAX 2000 IPS - Programming Procedure

CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 83 – NWA-008847-001 Rev.3.0
a6ch1001.fm
Programming Procedure
NOTE: SW3 of the MP card shall be set to 0.
DESCRIPTION DATA
Assign the RS port to output the command. •
(1)
(2)
Y=00
0: RS port 0
1: RS port 1
19 : MP-FP command output
NONE : No data
Assign command code to output. •
(1)
(2)
Y=2
00: Command code
00-FE : Command code to be output
NONE : Output all command codes
(1)
(2)
10: Command code
11: Command code
12: Command code
00-FE : Command code to be output
NONE : No data
Assign the FP number to output. •
(1)
(2)
Y=2
01: FP No.
00-63 : FP No. to be output
NONE : Output all command codes
(1)
(2)
20: FP No.
21: FP No.
22: FP No.
00-63 : FP No. to be output
NONE : No data
Assign the FPORT number to output. •
(1)
(2)
Y=2
02: FPORT No.
000-254 : FPORT No. to be output
NONE : Output all FPORT numbers
START
CM40
CMF6
A
JULY/01/2006
ONLINE MP-FP COMMAND OUTPUT