CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 113 – NWA-008847-001 Rev.3.0
a6ch1001.fm
Programming Procedure
Operating Procedure
By executing the command (CMFA Y=20) from MOC Add-In of MATWorX or CAT, you assign the IP
address of the terminal you want to send a ping request to. Then you confirm an reply message resulting
by executing the ping command.
Example: Assign “192.168.1.3” to IP address.
The following key operations are effective when the reply message resulting by executing the ping com-
mand is displayed.
• DE (space key): To send again a ping request to the same IP address as the last one.
• - (hyphen key) : To send a ping request to the IP address with 1 subtracted from the last one.
Example: The ping request is sent to “192.168.1.2” if you press DE (space key) after sending it to
“192.168.1.3”.
• S (return key) : To send a ping request to the IP address with 1 added to the last one.
Example: The ping request is sent to “192.168.1.3” if you press S (return key) after sending it to
“192.168.1.2”.
DESCRIPTION DATA
Execute a ping command. •
(1)
Y=20
XX ZZZZZZZZZZZZ
XX: 00: To execute a ping command
ZZZZZZZZZZZZ:
100000000001-255255255254:
IP address of the destination for the ping
command (12 digits)
NOTE: You can not assign the following data to IP addresses of the destination for the ping com-
mand.
• Top of the IP address is 0 (0xx.xxx.xxx.xxx)
• End of the IP address is 0 (xxx.xxx.xxx.xx0)
• End of the IP address is 255(xxx.xxx.xxx.255)
START
CMFA
END
FA20
ST DE DE
00192168001002
OCTOBER/14/2005
PING COMMAND
To Next Page
Loading...
