CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 6 – NWA-008847-001 Rev.3.0
a6ch1001.fm
HOW TO READ THIS CHAPTER
In the programming procedure, the meaning of (1), (2) and marking are as follows:
(1): 1st Data
(2): 2nd Data
: Initial Data
With the system data clear command (CM00, CM01), the data with this marking is automatically
assigned for each command.
: Command with this marking can be used only under Off-Line mode of the MP card.
To set Off-Line mode,
(1) Set SW3 on the MP card to “2” or “3”.
(2) Press SW1 on the MP card.
OFF LINE
HOW TO READ THIS CHAPTER
To Next Page
Loading...
