NEC NEAX 2000 IPS - Ping Command; General Description; Service Conditions

CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 109 – NWA-008847-001 Rev.3.0
a6ch1001.fm
PING COMMAND
[Series 3600 software required]
General Description
By executing a ping command from the Maintenance Administration Terminal (MAT) or the Customer
Administration Terminal (CAT), you can send a ping request to IP terminal (D
term
, IP-CS) from the PBX.
This enables you to confirm whether the IP terminal is correctly connected/set or not.
Service Conditions
(1) By executing a ping command (CMFA Y=20), only one ping request is sent from the PBX to the
terminal connected to the PBX with a LAN. And you confirm whether a reply to the ping request is
received from the terminal or not.
NOTE: You can send a ping request only once by executing a ping command once. So you can not set
the ping request parameter such as number of times that the ping request is sent by executing a
ping command.
(2) The time limit for replying to a ping request in this feature is fixed to about 2-4 seconds. If the time
limit is exceeded, “HARDWARE ERROR” is displayed.
(3) You can not execute the ping command from multiple MAT/CAT terminals at once. If you do that,
“WAIT, BUSY NOW” is displayed.
PBX
Executing a ping command
(CMFA Y=20)
Display of a ping request
transmission result
MAT (PC)
LAN
D
term
IP
N
E
C
N
EC
E
x
it
Exit
H
e
l
p
H
e
l
p
M
I
C
M
I
C
1
2
OCTOBER/14/2005
PING COMMAND