CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 84 – NWA-008847-001 Rev.3.0
a6ch1001.fm
DESCRIPTION DATA
Assign the display of IN command/OUT com-
mand.
•
(1)
(2)
Y=2
03: IN command/OUT command setting
0 : Display both IN command/OUT
command
1 : Display only OUT command
2 : Display only IN command
3 : Not displayed
CCC: Clear all the data of CMF6 Y=2
Assign the displayed terminal •
(1)
(2)
Y=2
04: Specification of displayed terminal
0: Other than MATWorX
1: MATWorX
NOTE: When using the communication software, set the second data to 0.
Assign whether to insert a line feed for each
command.
•
(1)
(2)
Y=2
06: Whether to insert a line feed or not
0 : Inserted after each command
1 : Not inserted after each command
NOTE: When executing command output in online mode (SW3 of MP card is set to 0), regardless
of second data setting, insert a line feed for each command.
Assign whether to add Minute/Second Indica-
tion to the header.
•
(1)
(2)
Y=2
07: Minute/Second Indication
0 : Add Minute/Second Indication to the
header
1 : Not add Minute/Second Indication to
the header
NOTE: This command is effective when second data of CMF6 Y=2>06 is set to 0.
A
CMF6
B
JULY/01/2006
ONLINE MP-FP COMMAND OUTPUT
To Next Page
Loading...
