NEC NEAX 2000 IPS - CHAPTER 3 SYSTEM DATA PROGRAMMING

CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 85 – NWA-008847-001 Rev.3.0
a6ch1001.fm
• To display whether command data is stored, and to clear the stored data in command buffer, do the
following programming.
DESCRIPTION DATA
Assign specification of particular data to out-
put.
•
(1)
(2)
Y=2
30: Specification of particular data for
command code of CMF6 Y=2>00
31: Specification of particular data for
command code of CMF6 Y=2>10
32: Specification of particular data for
command code of CMF6 Y=2>11
33: Specification of particular data for
command code of CMF6 Y=2>12
XXXZZ
XXX : 000-254: Byte location of com-
mand data
ZZ : 00-FF: Byte data
NONE : No data
NOTE: When setting this data, only the command of YY is output by XXXth byte of MP-FP com-
mand.
Assign Station number or Trunk number to
output Status Output.
•
(1)
(2)
Y=2
40: Status Output
X-XXXXXXXX: Station No.
DXXX : Trunk No.
XXX: 000-255
NONE : No data
DESCRIPTION DATA
Assign displaying the stored data in command
buffer and clearance of the stored data in com-
mand buffer.
•
(1)
(2)
Y=2
99: Displaying the stored data in command
buffer and clearance of the stored data
in command buffer
0 : No stored data
1 : Stored data remain
CCC: Clear the buffer
B
CMF6
END
START
CMF6
END
JULY/01/2006
ONLINE MP-FP COMMAND OUTPUT