CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 89 – NWA-008847-001 Rev.3.0
a6ch1001.fm
NOTE: To use Hyper Terminal, select File Properties, and set emulation to VT100.
• To collect the fault logs and call logs, be sure to set the MP card to on-line mode (set SW3 switch
to 0).
(2) Conditions of fault log collection
• By collecting fault logs, you can specify the reset causes and reset time.
• By collecting fault logs, you can calculate the number of sending control packets, the number of re-
sending control packets, the number of failed re-sending control packets, the number of received
control packets, the received error control packets, and the error number of control sequences.
• The fault logs are collected by the following timing.
- When D
term
IPs or IP-CSs login to the system, and when the IP-PAD card is in online status
- When you set the office data for fault logs collection (CMEA Y=6>11) from MAT/CAT
• The output format of fault logs is as follows.
21234567 04/09/13 12:01:40
DATA=1:RESET CAUSE
1=090B09DF 04/09/10 21:40:55 2=090B09DF 04/09/10 21:42:43
3=0644058B 04/09/10 22:13:19 4=09440AE4 04/09/11 08:59:05
5=09440AE4 04/09/11 09:07:23 6=07440A12 04/09/11 09:07:48
7=0644058B 04/09/11 09:11:43 8=0644058B 04/09/11 09:45:29
DATA=2:CONTROL PACKET COUNTER (PROTOCOL=2)
1=00000362 2=00000362 3=00000011 4=00000002
5=00000365 6=00000350 7=00000001
DATA=3:REGISTRATION NG
1=FF-DRS0 2=FF-DRS0 3=FF-DRS0 4=FF-DRS1
5=FF-DRS1 6=FF-DRS1 7=FF-DRS2 8=FF-DRS2
TIME OUT
12
334
3
7
3
8
9
5
6
4 5
JULY/01/2006
VoIP LOG COLLECTION
To Next Page
Loading...
