NEC NEAX 2000 IPS - Page 28

CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 18 – NWA-008847-001 Rev.3.0
a6ch1001.fm
(2) To clear the MJ/MN alarm by external key
DESCRIPTION DATA
Assign the card number for External Key
Interface (PN-DK00) to the desired LEN.
NOTE1: We recommend the setting of card
number for External Key Interface
by CM14, when using Series 3200
R6.2 software or later.
NOTE2: The card number of the External
Key Interface (PN-DK00) must be
assigned to the first LEN (LEVEL
0) and third LEN (LEVEL 2) of
each card slot.
NOTE3: Circuit No. 3 of E963 is used for
built-in External Key Interface of
MP card by setting CM61.
(1)
(2)
000-763: LEN
E900-E963:
Card No. of External Key Interface
(PN-DK00)
For PIM0/1: E900-E915
For PIM2/3: E916-E931
For PIM4/5: E932-E947
For PIM6/7: E948-E963
Assign the card number for External Key
Interface (PN-DK00) to the desired LEN.
[Series 3200 R6.2 software required]
NOTE1: The card number of the External
Key Interface (PN-DK00) must be
assigned to the first LEN (LEVEL
0) and third LEN (LEVEL 2) of
each card slot.
NOTE2: Circuit No. 3 of E963 is used for
built-in External Key Interface of
MP card by setting CM61.
(1)
(2)
XX ZZZ: LEN
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
E900-E963:
Card No. of External Key Interface
(PN-DK00)
For FP No.00: E900-E915
For FP No.01: E916-E931
For FP No.02: E932-E947
For FP No.03: E948-E963
Assign the function of MJ/MN alarm
clear key to the external key.
•
(1)
(2)
Y=30
XX Z
XX : 00-63 : Card No. of PN-DK00
Z : 0-3 : Circuit No.
633 : MP built-in External Key Interface
00: MJ/MN alarm clear key
CM61
CM10
START
END
CM14
FAULT MESSAGE