CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 20 – NWA-008847-001 Rev.3.0
a6ch1001.fm
STEP3: Click . Current Fault Configuration is displayed.
NOTE 1: The “Standard” column setting of Current Fault Configuration is equal to the initial data of the
CMEA Y=2.
STEP4: To accept the standard settings, click .
STEP5: To change the standard settings, click and select the alarm kind.
Then click to update the data settings into the PBX.
NOTE 2: Some Standard settings of the fault kind cannot be changed by this Add-In.
Click this button
FAULT MESSAGE
To Next Page
Loading...
