CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 23 – NWA-008847-001 Rev.3.0
a6ch1001.fm
STEP5: After resolving the fault, click to clear the alarms.
When the following dialog is displayed, click OK. All of MJ/MN/- - alarms are cleared.
NOTE 1: Only MJ alarm or MN alarm cannot be cleared by MAT Add-In (Fault Display).
To clear each alarm, enter CMEA Y=1>01 (MJ alarm), 02 (MN alarm) using MAT Add-In
(MOC).
NOTE 2: Fault Display can be started automatically on schedule by setting the time with the Scheduler.
For details, see “STARTING ADD-IN OR APPLICATION ON SCHEDULE” on
Page 248.
See the example of fault message display using MAT Add-In in the following pages.
FAULT MESSAGE
To Next Page
Loading...
