NEC PH2601QL - Power Supply

iii
Important Information
WARNING
Do not do it
1. Do not use the projector with the supplied lens cap
orequivalentwhile the projector is operating.This
may cause the lens cap to heat up and deform or
melt.
2. Do not place any objects, which are easily affected
by heat, in front of the projector lens.Doingsocould
lead to the object meltingfromtheheat that is emit-
ted fro
mthelightoutput.
Itis possible to vertically set up this deviceat360degrees.
Donotusetheprojectorwithitleaningtotheleftandright.
Thismayresultinamalfunction,however,portraitinstal-
lationispossible.Pleasereadthewarningsconcerning
portraitorientationbeforesettingtheprojectorinportrait
orientation.
Power Supply
1. Consult your distributor for installingthepower cable
to the projector.DONOTinstallthe power cable by
yourself.Doingsomaycauseareorelectricshock.
 Theprojectorissodesigned that it operates with the
power supplyvoltagedescribedbelow.
 ForC1connection
 (WhentheAC power to the projector power supply and
thelightpowersupply is provided by asinglecable)
• AC200V-240Vsinglephase 50/60Hz
ForC2connection
(WhentheACpowerto the projector power supply
andthelight power supply is provided by separate
cables)
• AC200V-240Vsinglephase50/60Hz(projector
power supply)
• AC200V-240Vsinglephase50/60Hz(lightpower
supply)
Ensurethatyourpowersupplytsthisrequirement
beforeattemptingtouse your projector.
2. Thepowercableis not included with the projector.
Askyour distributor for the power cable to select and
purchase. Use a power cable that meets the standards
andpowersupplyvoltage of the country where you
areusingthe projector.
 Referto“2.ConnectingthePowerCable”(→ page
17)fordetailsonconnectingthepower cable.
3. Handle the power cable carefully. A damaged or
frayed power cable can cause electric shockorre.
• Donotbendortugthepowercableexcessively.
• Donotplacethe power cable under the projector,
or any heavy object.
• Do not cover the power cable with other soft ma-
terials such a
srugs.
• Donotheat the power cable.
4. Placingthepowercableandthesignal cable closely
to each other can cause beatnoise.Ifthishappens,
keep the two separated so that beat noise is not
generated.
Beat noise is corruption of the picture often seen as
arollingbandmovingthroughtheimage.
5. Do not touch theprojector during a thunder storm.
Doingsocancauseelectricalshockorre.
6. Wheninstalledontheceiling,installthebreakerina
location that is easy to reach by hand.
CAUTION
Thisequipmentisdesignedtobeusedinthecondition
ofthepowercableconnectedtoearth.Ifthepower
cable is not connected to the earth, it may cause
electricshock.Pleasemakesurethepowercableis
earthed properly.