NEC PH2601QL - Power Options

114
5. Using On-Screen Menu
[POWER OPTIONS]
EnablingDirectPowerOn[DIRECTPOWERON]
Turnstheprojectoronautomaticallywhenthepowercableisinsertedintoanactivepoweroutlet.Thiseliminatesthe
needtoalwaysusethePOWERbuttonontheremotecontrolorprojectorcabinet.
TurningOntheProjectorbyDetectingInputSignal[AUTOPOWERONSELECT]
Underthestateofstandby,theprojectorautomaticallydetectsandprojectssynchronizingsignalinputfromthese-
lected terminals by this function.
OFF ........................ AUTO POWER ON SELECT function becomes inactive.
HDMI1, HDMI2, DisplayPort1, DisplayPort2, HDBaseT, SDI1, SDI2, SDI3, SDI4, SLOT
.............................. When the projector detects the computer signal input from the selected terminal, automatically it will be
turned ON and will project the computer screen.
NOTE:
• IfyouwanttoactivatethisAUTOPOWERONSELECTfunctionafterpoweringOFFtheprojector,interruptsignalfrominput
terminalsorpulloutthecomputercablefromtheprojectorandwaitforover3secondsandtheninputsignalfromtheselected
terminal.