NEC PH2601QL - Page 91

74
5. Using On-Screen Menu
Using the Entry List
Whenscreensettingsaremadeorlensmemoryregistrationisconducted,thesignaladjustmentsareautomatically
registeredintheunit’ssignallist.The(adjustmentvaluesof)registeredsignalscanbeloadedfromtheEntryList
whenever necessary.
However,onlyupto100patternscanberegisteredintheEntryList.When100patternshavebeenregisteredinthe
EntryList,anerrormessageisthendisplayedandnoadditionalpatternscanberegistered.Youshouldthusdelete
(adjustmentvaluesof)signalsthatarenolongerneeded.
Displaying the Entry list
1. PresstheMENUbutton.
The menu will be displayed.
2. Press the ◀ or ▶buttontoselect[INPUT].
 TheINPUTlistwillbedisplayed.
3. Use the ◀, ▶, ▲, or ▼toselect[ENTRYLIST]andpresstheENTERbutton.
 TheENTRYLISTwindowswillbedisplayed.
 IftheENTRYLISTwindowisnotdisplayed,switchthemenuto[ADVANCED].
 Toswitchthemenubetween[ADVANCED]and[BASIC],select[SETUP]→[CONTROL]→[TOOLS]→[AD-
MINISTRATORMODE]→[MENUMODE].(→ page 100)