Adding Options 5-53
The cable connector for a 5 1/4-inch diskette drive is
keyed to fit only in the correct position. The colored edge of
the cable goes to pin 1 on the cable connector. Align the red
edge of the cable with pin 1 (the notched end) on the drive
connector.
Align the colored edge of the cable with the pin 1 side of the
system board diskette drive cable connector. Pin 1 on the
system board diskette drive connector is on the end closest
to the rear of the system.
The following figure shows a three-connector diskette drive
signal cable.
Optional three-connector diskette drive signal cable
To Next Page
Loading...
