2-24 Setting System Parameters
Load Previous Values
If, during a Setup session, you change your mind about
your selections and have not yet saved the values to
NVRAM, you can restore the values you previously saved
to NVRAM.
Selecting Load Previous Values on the Exit menu updates
all the selections and displays this message:
CMOS values have been loaded!
Press <space> to continue
Save Changes
Save Changes saves all the selections without exiting Setup.
You can return to the other menus if you want to
review and change your selections.
FLASH UTILITY
Check the NEC Bulletin Board Service (BBS) for available
updates to your system BIOS. You can obtain information
to update your system with the latest BIOS version from the
NEC Bulletin Board Service.
See “NEC Bulletin Board Service” at the end of this chapter
for information about using the bulletin board (available in
the U.S. and Canada).
MOUSE DRIVER
Mouse driver software contains the basic operating
instructions between the computer and your mouse. It
tracks mouse position, gets data from the mouse buttons,
and displays a text cursor or graphics pointer on the screen,
based on information from your mouse and application.
See the following sections to run mouse drivers for your
operating system.
To Next Page
Loading...
