5-56 Adding Options
Installing a Storage Device in the Desktop
Use the following procedure to install a storage device in
the desktop system.
1. Follow the preinstallation instructions that come with
your device, such as setting jumpers and switches.
See “Device Preparation” earlier in this chapter for
device preparation information.
NOTE
If your 5 1/4-inch device comes with drive
rails, do not attach them. Remove any rails already
attached. See the documentation that comes with
the device.
2. Remove the system unit cover (see Chapter 4).
!
WARNING: Be sure that the system
power is
off
and the system and its peripherals
are
unplugged
before you begin the installation
procedure.
3. Remove the 3 1/2-inch drive bracket containing the
standard 1.44-MB diskette drive and hard disk as
follows.
To Next Page
Loading...
