5-78 Adding Options
Setting Up the Speakers
Use the following procedure to set up your speakers:
1. Open the covers at the rear of the speakers (see the
following figure). Pull out the speaker cables.
2. Replace the covers.
3. Connect the right speaker cable to the Speaker Out jack
at the rear of the system (see the following figures).
4. Connect the 6-volt AC adapter that comes with your
multimedia system as follows:
!
CAUTION: Do not install batteries in
the speakers with an AC adapter installed.
■ Plug one end of the AC adapter to the DC 6V jack on
the right speaker.
■ Connect the other end of the adapter into a properly
grounded wall outlet.
To Next Page
Loading...
