2-12 Setting System Parameters
Boot Sequence
Your system might require a Supervisor password to set
Boot Sequence parameters. Select “Boot Sequence” directly
from the Main Menu summary window to display the “Boot
Options” menu.
Use the legend keys to make your selections and exit to
the Main Menu. Use the following table to select your
boot options.
Boot Parameters
PARAMETERS OPTIONS DESCRIPTION
Boot Sequence A: then C: (default)
C: then A:
C: only
The BIOS attempts to load the
operating system from the disk
drives in the sequence selected
here.
“C: only” (under Supervisor
password control) provides virus
protection.
Setup Prompt Enabled (default)
Disabled
Displays “Press <F2> for Setup”
during bootup.
POST Errors Enabled (default)
Disabled
At boot error, pauses and displays
“Press <F1> to resume, <F2> for
Setup”.
Floppy Check Enabled (default)
Disabled
Seeks diskette drives during boot-
up. Disabling speeds boot time.
Summary Screen Enabled (default)
Disabled
Describes system configuration at
the end of boot-up.
To Next Page
Loading...
