Setting System Parameters 2-3
HOW TO START SETUP
To start the Setup utility, follow these steps:
1. Turn on or reboot your system. Setup displays the
following message:
Press <F2> to enter SETUP
2. Press F2. Setup’s Main Menu window appears similar
to the following screen.
NOTE
The screen shown is typical of your sys-
tem. The actual items on the Main Menu depend
upon the hardware installed in your system.
Main Menu
PhoenixBIOS Setup — Copyright 1992-95 Phoenix Technologies Ltd.
Main Advanced Security Power Exit
System Time: [10 :19:20] Item Specific Help
System Date: [03/12/1995]
Diskette A: [1.44 MB, 3 ½"] <Tab>, <Shift-Tab>, or
Diskette B: [Not Installed] <Enter> selects field.
> IDE Adapter 0 Master: C: 540 Mb
> IDE Adapter 0 Slave: None
> IDE Adapter 1 Master: None
> IDE Adapter 1 Slave: None
Video System: [EGA/VGA]
> Memory Shadow: [Enabled]
> Boot sequence: [A: then C:]
> Numlock: [Auto]
System Memory: 640 KB
Extended Memory: 7 MB
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ←→ Select Menu Enter Select > Sub-Menu F10 Previous Values
To Next Page
Loading...
