5-72 Adding Options
10. Connect external peripherals and power cables.
11. Run the Setup program to set your new configuration
(see Chapter 2).
EXTERNAL PERIPHERALS
This section contains instructions for connecting the
following external peripherals to the system unit ports:
■ a parallel printer to the parallel printer port
■ two RS-232C devices, such as a pointing device and
serial printer, to the serial 1 and serial 2 ports
■ multimedia components (for multimedia models), which
include the speakers and microphone that come with the
system, to the sound board
■ a telephone line to the fax/modem ports (for fax/modem
models).
Parallel Printer
Use the following steps to connect a parallel printer to
your system unit. If you have a serial printer, see the
next section, “RS-232C Device.”
NOTE
Before connecting a printer to your
system, be sure that you have set up the printer
correctly. Follow the setup instructions that come
with the printer.
1. Turn off and unplug the system unit and any external
option connected to the system unit.
2. Make sure that your printer power is off and the power
cable is unplugged.
To Next Page
Loading...
