Setting System Parameters 2-15
Integrated Peripherals Parameters
FEATURE OPTIONS DESCRIPTION
COM1 Port
COM2 Port
Disabled
User-selectable
settings
Auto
Selects a unique address and
interrupt request for the listed
COM ports. Auto selects the
next available combination.
Factory settings:
COM1 default: 3F8, IRQ4
COM2 default: 2F8, IRQ3
The fax/modem board uses the
COM3 port (IRQ2) setting.
LPT Port Disabled
378, IRQ 5 (default)
User-selectable
settings
Auto
Selects a unique address and
interrupt request for the LPT port.
Auto selects the next available
combination.
LPT Mode Output only (default)
Bi-directional
ECP
Enables parallel port to function
normally (Output only),
bidirectionally, or in an enhanced
capabilities port (ECP) mode.
Check your printer documentation
to set the correct LPT mode for
your printer.
Diskette
Controller
Enabled (default)
Disabled
Enables the on-board diskette
drive controller.
Local Bus IDE
Adapter
Both (default)
Primary
Disabled
Enables the on-board IDE
controllers.
The Both option enables the
primary (fast) channel and
secondary (standard) channel.
The Primary option enables only
the primary (fast) channel.
To Next Page
Loading...
