Adding Options 5-59
■ Remove the blank panel by pressing the panel tabs
from the inside of the front panel and pushing the
blank panel out.
Locating the blank panel tabs
■ If there is a perforated metal plate in front of the
device slot, remove the plate by pulling it back and
forth until it releases from the chassis.
5. Replace the front panel. Secure the panel in place with
the five screws you removed earlier.
6. Insert the device, connector end first, into the device slot.
NOTE
To easily access device connectors for
cabling, do not insert a 5 1/4-inch device all the way
into the slot.
To Next Page
Loading...
