5-64 Adding Options
9. Replace the 3 1/2-inch device bracket in the 3 1/2-inch
device slot. Take care to prevent pulling and loosening
cable connections.
Secure the device bracket in place with the four screws
you removed earlier.
Securing the 3 1/2-inch drive bracket
10. If you installed a 1.2-MB diskette drive, remove the
protective cardboard insert from the drive.
11. Replace the system unit cover (see Chapter 4).
Be sure that you do not pinch any cables or wires when
you replace the cover.
12. Connect external peripherals and power cables.
13. Run the Setup program to set your new configuration
(see Chapter 2).
To Next Page
Loading...
