EasyManua.ls Logo

NEC PowerMate V486 Series - Page 212

NEC PowerMate V486 Series
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Solving Problems 7-5
Troubleshooting
PROBLEM CORRECTIVE ACTION
Boot Problems
The system does not boot
because you forgot a previously
set password.
See “Clearing Your Password” in Chapter 6.
CD-ROM Problems
The system does not see the
CD-ROM reader.
Be sure to use the appropriate drive
designation. The CD-ROM reader is
assigned as drive E.
The reader is unable to read a
disc.
Check that the disc is inserted in the CD tray
with the label printed side up. Check that the
disc is a data disc, not a music disc. Try a
different disc to see if the problem is limited
to one disc.
CD-ROM disc does not eject due
to a power failure or software
error.
Power off the system. See “Emergency
Eject” in this chapter.
Cannot play music CD/
Use sound software (see your
Ensemble
User’s Guide
).
Speaker Problems
No sound from speakers. Check that speaker power is on. A power
button on the front of the right speaker
controls power to the speakers.
Speaker volume is too low. Adjust the volume control on the right
speaker. If the sound level is still too low,
adjust the volume through system software
(see your
Ensemble User’s Guide
).
Sound coming from only one
speaker.
Balance the speaker output by adjusting the
balance knob on the rear of the right speaker.

Table of Contents

Related product manuals