C-2 CD-ROM Reader Configuration
■ Audio connector
Provides an audio output to connect digital audio to a
sound board.
■ Configuration Jumpers
Set the CD-ROM reader as the master or slave device on
the IDE interface port (see the following section).
■ IDE cable connector
Connects the system’s IDE interface to the CD-ROM
reader. Connect the IDE interface cable from the
standard IDE port (IDE2 connector) to this connector.
Align the colored edge of the IDE interface cable with
the pin 1 side of the IDE interface connector.
■ Power connection
Provides a power connector for operating power from
your computer.
To Next Page
Loading...
