NEC Storage Manager - Pool Information View

Chapter 7 Disk Array Configuration Setting
IV-97
7
7
7
.
.
.
4
4
4
.
.
.
4
4
4
P
P
P
o
o
o
o
o
o
l
l
l
I
I
I
n
n
n
f
f
f
o
o
o
r
r
r
m
m
m
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
V
V
V
i
i
i
e
e
e
w
w
w
Selecting a basic pool or dynamic pool in the configuration tree view shows the pool info view. You can see the
information about the pool by the physical disk and logical disk.
(1) [Logical Disk] tab
The [Logical Disk] tab shows a list of logical disks used in the pool. For the logical disks displayed, you can
expand their capacity, change the rebuild time, rename them, and unbind them on this tab. If you select
Dynamic Pool for using snapshots, you can unbind generations. For operation of snapshots, refer to the
“Snapshot User’s Manual (Function Guide)” (IS030).
Figure 7-83 Pool Information View - [Logical Disk] Tab
The [Logical Disk] tab displays the following information. However, [Snapshot Type] and [RPL Type] are
displayed only when each license is canceled.
y Number: Number of the logical disk (hexadecimal, 4 digits)
y OS Type: Format of the logical disk
y LD Name: Name of the logical disk (up to 24 characters)