Chapter 8 Disk Array Configuration Setting (S100/S1100/S1200/S1300/S2100/S2200/S2300)
IV-118
Omitted: 5, 6, 7...
0 specified: 2, 5, 6...
10 specified: 10, 11, 12...
y Format Time
Specifies the maximum LD Format Time.
It is possible to select 0 to 24 hours as Format Time. When 0 is specified, the formatting is performed at
the maximum speed. Moreover, the time is an indication and it does not always take the time as specified.
The specified time is the standard time required. However, the actual execution time varies with the load of the
disk array.
Specify 0 to complete the LD binding at the maximum speed. If the business operation I/O is preferred, specify a
large value (such as 24) to lower the load to the Disk Array.
To Next Page
Loading...
