Chapter 10 Access Control Operations
IV-218
Perform individual operations for LD Sets on the following screen
Figure 10-32 [AccessControl] Tab Screen
(3) [Get Disk Array Info.] button
Clicking this button will re-acquire information from the disk array necessary for operations on the AccessControl
screen.
Normally, it is not necessary to use this button to re-acquire information from the disk array. If operations for
the disk array on this screen fail, causing inconsistency between the disk array setting information and the
information administrated on the iSM client and making normal operation impossible, use this button.
After clicking this button and while information is being acquired from the disk array, the following dialog screen
will be displayed.
Figure 10-33 Information Being Acquired
To Next Page
Loading...
