NEC Storage Manager - Page 330

Appendix F Batch Setup File
40
DiskArrayName
y Specify the name of the disk array in which the AT-group is created.
y The disk array name can be specified with up to 32 characters.
(8) To register volumes to the AT-group created, write “[atadd]”.
(9) Specify the [atadd] items in the following format:
“ATgroupName”, “MV Vol Type”, “MV Vol Name”
<SYNTAX>
ATgroupName
y Specify the name of the AT-group to which the volume is created.
y The AT-group name can be specified with up to 32 characters.
MV Vol Type
y Specify the format of the master volume to be registered.
MV Vol Name
y Specify the logical disk name of the master volume to be registered.
y The logical disk name can be specified with up to 24 characters.
(10) To delete volumes already registered to an AT-group, write “[atremove]”.
(11) Specify the [atremove] items in the same manner as [atadd].
“ATgroupName”, “MV Vol Type”, “MV Vol Name”
(12) To delete an AT-group, write “[atdelete]”.
(13) Specify the [atdelete] items in the following format:
“ATgroupName”
<SYNTAX>
ATgroupName
y Specify the name of the AT-group be deleted.
y The AT-group name can be specified with up to 32 characters.