Chapter 7 Disk Array Configuration Setting
IV-15
(6) Setting detailed parameters
Clicking the [Next] button on the “PD Selection” screen displays the “Detail Parameter Setting for Pool Binding”
screen.
Figure 7-8 Setting Detailed Parameters
Pool Name: Specify the name of the pool. This screen initially puts the name automatically assigned in
the form of “Pool” + Number (hexadecimal, 4 digits) in the field. Note that you cannot
specify any name already used in the disk array.
Any pool name that does not conform to the following rules is invalid:
y Number of available characters: 1 to 24 characters
y Available characters: Alphabet: A to Z (a to z)
* Upper- and lower-case characters are distinguished.
Numerals: 0 to 9
Underbar: _
Slash: /
* All the characters must be 1-byte characters.
To Next Page
Loading...
