Issue 1.0 VM8000
3 - 26 Programming
47-02-09 Auto Attendant Do Not Disturb (Auto-ATT DND)
Use this option to enable or disable Auto Attendant Do Not Disturb. When a
subscriber enables Auto Attendant Do Not Disturb, an Automated Attendant
caller routes directly to the mailbox, hears the greeting, and is asked to
leave a message. A subscriber can also enable Auto Attendant Do Not
Disturb while recording their mailbox greeting.
See Auto Attendant Do Not Disturb on page 2-39 for more.
Options
1 (Yes - enabled)
0 (No - disabled)
Default
0 (No - disabled)
47-02-10 Forced Unscreened Transfer (Forced UTRF)
Use this option to enable or disable Automated Attendant Forced
Unscreened Transfer for the Subscriber Mailbox. If enabled, each Screened
Transfer (TRF) to the extension is converted to an Unscreened Transfer
(UTRF). If disabled, Screened Transfers from the Automated Attendant
occur normally.
See Forced Unscreened Transfer on page 2-103 for more.
Options
1 (Yes - enabled)
0 (No - disabled)
Default
0 (No - disabled)
47-02-11 Auto Time Stamp
Use this option to enable or disable Auto Time Stamp for the Subscriber
Mailbox. If enabled, after the subscriber listens to a message VM8000
InMail will announce the time and date the message was left. Auto Time
Stamp will also announce the message sender (if known).
A subscriber can also enable Auto Time Stamp from their mailbox.
See Auto Time Stamp on page 2-43 for more.
Options
1 (Yes - enabled)
0 (No - disabled)
Default
0 (No - disabled)
To Next Page
Loading...
