Issue 1.0
SIP Trunk Programming Guide 7
3.2 CC-CP00 Network Setup
Values shown are for example purposes only. Your actual IP values will be
determined by your local LAN administrator.
1. Select SV9300 Main/Remote Unit No. accommodating SIP Trunk
Channels, then click Read to get the current data settings.
2. FD=00 Enter SV9300 VoIPDB IP Address.
FD=01 Enter SV9300 VoIPDB Subnet Mask.
FD=02 Enter SV9300 VoIPDB Default Gateway Address.
3. FD=10 Set VoIPDB location number.
4. FD=36 Leave Blank to use default port 5060 for SIP trunk control
packets. Change this only at the request of Spectrum Enterprise. It was
requested to change for test environment.
Figure 3 CM 0B1xx Network Setup
To Next Page
Loading...
