Issue 1.0 Spectrum Enterprise
10 SIP Trunk Programming Guide
3.3 IP PAD Network Settings
Values shown are for example purposes only. Actual IP values will be
determined by your local LAN administrator.
1. Select SV9300 Main/Remote Unit No. accommodating SIP Trunk
Channels, then click Read to get the current data settings.
2. FD=00 Enter VoIP IPPAD IP address.
FD=10 Select number of VoIP IPPAD channels.
3. FD=40 Change this port only if recommended. 31000 was changed for
test environment. This will not likely need to be changed.
4. Click Apply.
Figure 5 CM 0B2xx IP PAD Network Settings
Command Line Example: Unit 01
CM 0B201>00>192.168.0.211 (Unit 01 VoIP IPPAD Address)
CM 0B201>10>32 (Unit 01 VoIP IPPAD Channels)
CM 0B201>40>31000 (RTP Base port setting)
To Next Page
Loading...
