NEC Univerge SV9300 - Figure 4 CM 0 B1 Xx Network Setup (Continued)

Issue 1.0 Spectrum Enterprise
8 SIP Trunk Programming Guide
5. Click Apply.
The SV9300 must be reset in order for the change to take effect.
1. Select SV9300 Main/Remote Unit No. accommodating SIP Trunk
Channels, then click Read to get the current data settings.
2. FD=60 Enter primary DNS server IP Address (optional).
FD=61 Enter secondary DNS server IP Address (optional).
FD=70 Enter global IP Address (optional).
 If more than 1 profile is used enter global IP address in CM BA139.
 The IP addresses shown are example only and will depend on the network for
the global address and Spectrum Enterprise for DNS specific information.
Command Line Example: Unit 01
CM 0B101>00>192.168.0.210 (Unit 01 VoIP Address)
CM 0B101>01>255.255.255.0 (Unit 01 VoIP Subnet)
CM 0B101>02>192.168.0.1 (Unit 01 VoIP Default GW)
CM 0B101>10>NONE (Default: Location 00)
CM 0B101>36>5061 (Default: SIP Trunk Port 5060)
Figure 4 CM 0B1xx Network Setup (continued)