Issue 1.0 Spectrum Enterprise
18 SIP Trunk Programming Guide
3.7 Route to Route Connection Settings
All values shown are for example purposes only. Your actual values will be
determined by your implementation team.
1. Select Incoming Trunk Route.
2. Select Outgoing Trunk Route and click the Read button to get current
data settings.
3. Select 0 to allow route to route connection.
Allow route to route connection (i.e. SIP route to PRI route, PRI route to SIP
route, and SIP route to SIP route).
4. Click Apply.
Figure 13 CM 36 Route to Route Connection Settings
Command Line Example:
CM 360>0101>0 (Route to Route Connection)
To Next Page
Loading...
