Necta Rondo - System Testing Procedures

P2125EN00
01 - 2008

9
5 - TEST
5
t
e s t
5.1
te s t s e l e c t I o n
This function is used to simulate the normal dispensing of products
without inserting any money to check the functioning of the spiral
rotation by pressing the selection buttons.
5.1 - TEST SELECTiON
5.2 - MOTOR TEST
5.3 - AUTOTEST
5.2
mo t o r t e s t
This function is used for actuating all motors in a sequence, indicat-
ing on the display the number of the involved selection.
5.3
a
u t o t e s t
This function allows testing, in a semiautomatic way, of the main ma-
chine components. When pressing the conrm button, the message
“AUTOTEST” will be start blinking.
It is possible to cancel each operation and go to the next one by
pressing the exit button, but conrming with the conrm button to
start the autotest routine. Some checks occur automatically, others
need the manual operation of the monitored component.
In a sequence:
- Push-button panel test; the machine will display the number of the
button which must be pressed and awaits the actuation before going
to the next button.
- Temperature test; the machine will display the value of temperature
detected by the probe. In the event of interruption the value -11.0 is
displayed; in the event of short-circuit the value 41.0 is displayed.
- Buzzer test; the machine will emit a series of test sounds.
- Compressor test; the compressor is activated/deactivated using
the “

” and “

” buttons.
- Selection test; the machine will simulate the dispensing of each
selection in a sequence.
- Coin mechanism test; the machine checks that communication
with the coin mechanism takes place correctly and which validator
lines are set as being active.
- Photocell test; in the event where the machine is equipped with a
device for detecting the passage of products the light beam reading
and interruption are checked.
- Dispensing compartment lock test; in the event where the machine
is equipped with a device for locking the dispensing compartment,
the “

” and “

” buttons are used for locking and unlocking the
compartment opening.
- Direct push-button test; the machine will display the number of the
button which must be pressed and awaits the actuation before going
to the next button.